[[TitleIndustry]]

Tips for quickly removing door and window film

Date:Dec 09, 2020

Many decoration friends know that a thin film is covered on the newly bought door. The function of these films is to protect the door from being damaged by other materials. It’s hard to tear off the newly bought without tearing off for a long time. So, is there any technique to quickly tear off the protective film? I will introduce you today.


1. How to remove the film on the door


1. Heating method with electric hair dryer.


Turn on the hair dryer to the maximum, and then blow it directly against the protective film for a while, the film will gradually soften by itself. At this time, we can use a normal eraser or a soft cloth to wipe off the offset printing effortlessly and tear off smoothly. Protective film. If there is residual glue on it, we can continue to blow it with air, and then glue the residual glue with the plastic film that has just been torn off. Finally, wipe the door again with clean water to make the whole look cleaner.


2. Fengyou exquisitely removes the protective film


The unloaded area can be completely soaked with wind oil, and after 15 minutes, we will use a soft cloth to wipe the area vigorously. If the dirt is still stubborn, you can extend the soaking time of Fengyoujing, and then rub it vigorously until it is wiped off.


3. White vinegar is also a good way


Dip white vinegar or vinegar with a dry dish cloth, completely cover the hard-to-remove part, soak it completely, soak it for 15-20 minutes, then use a rag to gradually wipe off the edge of the film.


4. Lemon juice removes stubborn positions skillfully


Rub the lemon juice on the place with sticker dirt and rub it repeatedly to remove the sticker marks.


5. Medical alcohol immersion offset printing


Drop an appropriate amount of medical alcohol on the surface of the hard-to-remove part of the film, and soak it for a while. Wipe it off with a soft cloth or paper towel. There are also, for example, expired perfumes or effective lotions, which can also be used to replace alcohol, because these are rich in alcohol.


6. Remove with acetone


Place an appropriate amount of acetone on the film, then soak for 10 minutes, then wipe it off with a rag. This method uses a small amount and is thorough. The best part is that it can remove these residual gums very quickly and easily, which is better than alcohol.


The above is the quick removal of door and window film tips, friends in need can try the above methods.


Previous: Is the gap in the middle of the wooden door closed? Here is a coup!

Next: What is a trackless sliding door?